Who needs a built 302?

EHA Racing

EHA Racing

Member Plus
#1
#1
I have 302's coming out my ears right now and would love to start putting some of them together.

1st one:
SOLD

2nd:
SOLD

3rd:
1972 302 Short Block, stock crank, stock rods, .030 cast pistons with 4 valve reliefs. This is basically a stock rebuild short block engine but with a strong block. Only comes with timing cover on the side.
$900 completely freshened and assembled with new standard volume oil pump.
I have a set of stock '69 302 and '72 351W and '94 GT heads that can be woked into the deal as well.
*This block is not a roller block. If a hydraulic roller cam is desired Retro-fit or link bar hydraulic roller lifters must be used. 1969 to 1974 Blocks are much stronger than later blocks due to the higher nickle content.*

4th:
1987 stock short block. This IS a roller block. Buy as is for $250 or completely rebuilt with for $1000.
Rebuild will consist of hone, bearings, rings, freeze plugs, timing chain and oil pump. Will also have stock H.O. cam installed. I have a set of stock '69 302 and '72 351W and '94 GT heads that can be woked into the deal as well.

I also have 3 solid roller cams and 5 solid flat tappet cams that could be worked into any deal.

Call or text Doug at (716) 450-1827 or email djvanstrom@eha.us.com
 
Last edited:
EHA Racing

EHA Racing

Member Plus
#6
#6
1st one:
400 HP / 325 ftlbs TQ, 310ci complete carb to pan. Seasoned roller block, Trick Flow Heads, Ross forged pistons, solid roller cam, ported vic Jr intake, ARP rod studs, ARP Main studs, ARP Head studs, Fluidamper balancer, Polished Valve covers, MSD pro billet distributor, Comp Cams rockers and stud girdle, Canton Pan, Quick Fuel carb. This is a street / strip engine with 9:1 compression and runs on pump gas.
$3,500 - dyno time only.
SOLD

2nd:
1974 302 Short Block, Stock '74 crank turned .010, Crower rods, .030 Wiseco Dome forged pistons for inline valve head, new main and rod bearings, new cam bearings, new Cloyes Hex-A-Just timing chain, timing cover.
Buy all the pieces for $1,500, Assembled for $1,800.
*This block is not a roller block. If a hydraulic roller cam is desired Retro-fit or link bar hydraulic roller lifters must be used. 1969 to 1974 Blocks are much stronger than later blocks due to the higher nickle content.*
Block is completely machined and ready for assembly.
SOLD
 
You must log in or register to reply here.