Search results

Yea, it looks a little intimidating. I am going to wrap the harness & take it 1 wire at a time run it to where it goes & move on to the next one. After I run all the wires, then I will cut them to length & hook them up. I have all winter to do this, & will probably need it too. On another note...

Thanks Bruce. Today I started the install of the AAW harness, & installed the relay pack.

Stu, thanks for the reminder.:nono:

Today I installed the new carpet, & installed the 2 firewall grommets for the new wiring harness.

Thanks Bruce. Today I finished the Fat Mat under carpet sound deadening insulation adding the pieces to the trans tunnel, & under the drivers side seat.

Today was another mild day so I figured I would finish the welding for the parking brake handle assembly. Here is a pic of the reinforcement plate from yesterday. I made a reinforcement plate cover to keep out debris & to cover the hole in the floor. I also welded 2 bolts to the cover so when...

Today I took advantage of the mild weather & rolled the Coupe out of the garage & welded in the reinforcement plate on the underside of the trans tunnel for the center mount parking brake.

Thanks Stu. Yesterday I removed the relay mounting plate, painted it so it doesn't rust & installed riv nuts for mounting the relays. Mounted the fuel pump cut off switch & reinstalled the mounting plate.

Thanks Bruce. Today I made a mounting plate for the AAW main wiring harness relay pack, & the fuel pump cut off switch. I am not using the factory parking brake, I am using a center mount hand brake from a 1987 Mustang so I bolted the mounting plate in the place of the foot brake.

I like your picture.